Selling my Cutthroat as I am going back to primarily riding a mtb and have a road bike with good clearance for greenway and pavement use. I bought this in August 2023 and upgraded all the touch points along with wheels and tires over the stock build.

The only mark on the frame is by the driveside rear dropout where the chain touch the paint once putting when swapping wheels in the stand. The levers and rear derailleur have some scratches from a small fall over when the bike was new (I hadn’t even left the shop yet so that was frustrating). The shop went over everything again before I left to make sure the hanger and levers were aligned and not damaged.

Upgraded the crankset to 170mm length Race Face Next SL G5 arms spinning in a Kogel ceramic bottom bracket with less than 1k miles of use. The chain rings are stock Easton gravel rings (30/46 tooth).

Seatpost is an Enve 0 offset carbon post with a Cadex Boost saddle. The handlebar is an Enve AR carbon bar in 42cm width on a 100mm Prime Doyenne Lightweight alloy stem. Stem is a +/- 5* rise.

Wheels are from Farsports and are custom built with DT350 hubs on XC34/30 carbon rims (30mm deep, 34mm external width, 28mm internal width). They are laced together with Sapim CX-Ray spokes and Sapim secure loc SILS brass nipples. These are 28 hole lacing front and back. Weight was 1,450 grams with tape and valves installed. when measured on my kitchen scale.

Tires are Schwalbe Thunderburt Evo with the Super Race casing in 29×2.10″ sizing. Frame will clear a 2.4″ tire in the back if you would want more tire. Tires only have about 300 miles on them and look practically new. They are setup tubeless using Silca Ultimate tire sealant.

Asking $3,750 OBO + shipping.